Free tool

Surface finish calculator

Enter the feed and the tool's nose, corner or ball radius, and see the roughness the cut leaves, its ISO grade, and how fast you can feed for the Ra on the drawing. Nothing is sent anywhere.

Operation
The cut
The drawing

The nose radius is the last number of an insert's code: CNMG 120408 has r = 0.8 mm. For a ball nose, the step-over between passes nearly always sets the finish.

Ra 0.9 µm

Meets Ra 1.6 µm: the theoretical finish is inside the drawing.

Rz (peak to valley)
3.52 µm
Rq (RMS)
1.05 µm
Ra in micro-inches
35.6 µin

ISO 1302 grades with their Ra in µm; the framed one is your target.

For Ra 1.6 µm, feed up to 0.199 mm/rev.

Rz 3.52 µmcentre line (Ra)0.15 mm
The profile the tip leaves: 0.15 mm apart with a 0.8 mm radius, 3.52 µm peak to valley. Heights are drawn 37 times larger than widths.

These are the theoretical values of the tip's shape alone: a radius moved a feed sideways leaves a row of arcs, Rz = r − √(r² − f²/4) (about f² / 8r) and Ra about f² / 31.2r. Real surfaces are rougher, by up to two or three times, from vibration, tool wear, built-up edge and the material tearing; a wiper insert is taken as halving the roughness. Use it to choose the feed and radius, then measure.

Turning calculator · Milling calculator · Machining power

Sell machined parts with the finish on the order

With Customazy your customers choose the material, the sizes and the surface finish of a part on your website and see its price at once. You receive the order with the part already drawn.