Free tool

Machining power calculator

Enter the cut and your machine's spindle, and see whether it has the power and the torque at that speed, which of the two runs out first, and how far the feed can go. Nothing is sent anywhere.

Process
Material and cut
Spindle

The rated power and base speed are on the motor's plate or in the machine's manual (take the continuous S1 rating). Below the base speed the motor gives full torque but less power, above it full power but less torque. Belt drives and older machines lose more on the way: set the efficiency lower.

75%

Room to spare: the cut takes 75% of what the spindle gives at this speed, where power sets the limit.

Power needed
5.65 kW
of 7.5 kW at this speed
Torque needed
22.5 N·m
of 29.8 N·m at this speed
Spindle speed
2,400 rpm
Above the base speed

At full load the spindle could carry about 1.46 times the feed: 0.117 mm per tooth.

Power the spindle gives7.5 kWTorque the spindle gives47.7 N·m1,500 rpm8,000 rpm
The spindle's power and torque up to 8,000 rpm: 7.5 kW from 1,500 rpm. The cut runs at 2,400 rpm and needs 5.65 kW and 22.5 N·m.
Power at the cut
4.52 kW
Removal rate
73.7 cm³/min
Feed rate
768 mm/min
Cutting force (kc)
3,680 N/mm²
Chip thickness
0.046 mm
Spindle's full torque
47.7 N·m

The cut's power is its removal rate times the material's cutting force at its chip thickness, as in the removal rate calculator. The spindle follows the usual simple curve: full torque up to the base speed, full power above it. Real motors also have short-time ratings above the continuous one and lose some power near their top speed. The cutting forces are typical values for each material group, a starting point rather than a supplier's figures.

Milling speeds and feeds · Turning speeds and feeds · Metal removal rate

Price machined parts as your customers order them

With Customazy your customers set the sizes and material of a part on your website and see the price at once, worked out from your own rates. You receive the order with the part already drawn.