Free tool

Chip thinning calculator

A narrow cut or a tilted edge cuts a thinner chip than the feed per tooth. Enter the cutter, the cut and your supplier's feed, and see the feed to set so the chip stays as thick as it should. Nothing is sent anywhere.

Cutter
The cutter
The cut

Take the recommended feed per tooth from the tool supplier: it is the chip thickness the edge is made for, given for full engagement and a 90° edge.

0.083 mm per tooth

Set this feed: 1.67 times the recommended one, for the same chip.

At 0.05 mm per tooth this cut would make a chip only 0.03 mm thick: the edge rubs instead of cutting, wears faster and the job takes longer.

Table feed as recommended
1,000 mm/min
Table feed corrected
1,667 mm/min
Faster by
+67 %
ae36.9°Chip thickness along the cut0.05 mm0°36.9°180°
Corrected feedFeed as recommended The tooth is in the material for 36.9°. At 0.083 mm per tooth its thickest chip is 0.05 mm; at the recommended feed it would be 0.03 mm.
Radial factor
× 1.667
Axial factor
× 1
Engagement angle
36.9°
Edge angle (κ)
90°
Average chip thickness
0.026 mm

The chip a tooth cuts is thickest where it leaves a narrow cut, at fz · sin φ (φ the engagement angle), and is thinner again by sin κ where the edge is tilted. These are the standard geometric corrections for a straight, sharp cutter; the supplier's highest feed per tooth, the tool's strength and the machine still set the limits.

Milling calculator · Surface finish · Machining power

Sell machined parts made to order

With Customazy your customers choose the material and the sizes of a part on your website and see its price at once. You receive the order with the part already drawn.