Free tool

Facing calculator

The time to face a bar or a tube on the lathe, and what the spindle does on the way to the centre, at constant cutting speed or at constant rpm. Nothing is sent anywhere.

Material and insert
Insert
The face
Your lathe
Spindle

Picking a material or insert fills in a cutting speed and feed to start from, for a rigid lathe. The insert's maker gives the right figures for its grade.

Time across the face
6 s
Spindle at the outside
875 rpm
Spindle at the centre
3,000 rpm
Average removal rate
50.7 cm³/min
Spindle power needed
2.76 kW
Torque at the outside
24.1 N·m
  • Below Ø 23.3 mm the spindle is at its top speed of 3,000 rpm, so the cutting speed falls from there to the centre.
Top speed 3,000 rpmØ 80Centre
Spindle speed from Ø 80 mm to Ø 0 mm: 875 rpm at the outside, 3,000 rpm at the inside
Volume removed
5.03 cm³
Removal rate at full speed
55 cm³/min
Cutting speed at the centre
0 m/min
Chip thickness
0.249 mm
Surface roughness Ra
2.44 µm
Power at the insert
2.21 kW

One facing pass from the outside in, at the feed set, with no time for the approach or the retract. The time at constant cutting speed adds up the faster revolutions towards the centre; at constant rpm it is the radius over the feed rate. Power and torque are worked out at the outer diameter, where the cut is heaviest, from the material's specific cutting force; the finish is the theoretical one from the feed and the nose radius.

Turning along the bar: the turning calculator · Removal rate on its own: the metal removal rate calculator

Sell turned parts made to order

With Customazy your customers set the diameter, length, material and quantity of a part on your website and see its price at once. You receive the order with the drawing and a work order for the lathe.