Free tool

Stepper driver Vref

Pick the driver and its sense resistor, type each motor's rated current and how much of it to use: you get the reading to set with the multimeter for X, Y, Z and the extruder. Nothing is sent anywhere.

Rs is the small resistor next to the chip, printed R100 (0.100 Ω), R110 or R068. Choosing a driver fills in the value most of its boards carry.

The motors
Rated currentUseXYZExtruder

The rated current is the motor's current per phase on its datasheet (most NEMA 17 motors take 1 to 2 A). Usual use: X and Y 80–90 %, Z 70–80 %, the extruder 60–80 %. Type 0 for an axis with no motor.

TMC2209 · Rs 0.11 Ω · multimeter on DC volts

  • X1.275 V1.28 A peak · 0.90 A RMS
  • Y1.275 V1.28 A peak · 0.90 A RMS
  • Z1.125 V1.13 A peak · 0.80 A RMS
  • Extruder0.700 V0.70 A peak · 0.49 A RMS

TMC drivers in standalone mode take their current from this voltage. If your firmware sets the current over UART (Marlin, Klipper), set it there in mA RMS instead.

Setting it

  1. Power the board with the motors connected and idle, not moving.
  2. Set the multimeter to DC volts. Put the black probe on the board's ground (GND) and the red one on the potentiometer's metal top.
  3. Turn the potentiometer in small steps with a ceramic or plastic screwdriver; a metal one can short the board.
  4. Stop at the reading above, then print. If a motor is too hot to touch after 10 minutes, take 5–10 % off; if layers shift or steps are lost, add a little.

TMC2208/2209/2225/2226: Vref = I RMS × √2 × (Rs + 0.02 Ω) × 2.5 / 0.325, with I RMS = I peak × 0.707. Check your board's documentation: some boards differ from the reference design.

Run a 3D printing service from one place

With Customazy your customers upload a model on your website, pick the material and see the price at once. Orders, machines and the queue are in one panel.