Free tool
Depth of cut for milling
How deep (ap) and how wide (ae) should the end mill cut? Pick the material, the cutter and what you are milling, and get a cut to start from, drawn to scale. Nothing is sent anywhere.
Depth of cut (ap)
15 mm
150 % of the diameter
Width of cut (ae)
5 mm
50 % of the diameter
Shoulder · Aluminium · Ø10 mm, 3 flutes · Solid carbide
- Passes to the depth
- 2 × 15 mm
- Engagement angle
- 90°
- Chip thinning factor
- × 1
- Teeth in the cut
- 0.8
Starting values from common end mill makers' tables for a square end mill. Take the first cut at these values, listen and look at the chips, then raise or lower them. Your supplier's figures for the cutter come first.
The terms
- Depth of cut (ap)
- The axial depth: how far down the side of the cutter is in the material, measured along the cutter's axis.
- Width of cut (ae)
- The radial width, or stepover: how much of the cutter's diameter is in the material, measured across it. A slot is ae = D.
- Engagement angle
- The arc of the cutter's turn in which a tooth is cutting. Wider cuts mean a longer arc, more heat and more teeth cutting at once.
- Chip thinning
- Below half the diameter a tooth leaves the cut before the chip is fully thick, so the feed per tooth can be raised to keep the chip the right thickness.
- Stick-out
- How far the cutter comes out of the holder. Deflection grows with the cube of it, so the shortest stick-out that reaches the depth is the stiffest.
Sell machined parts made to order
With Customazy your customers set the size, material and quantity of a part on your website and see its price at once. You receive the order with the drawing and a work order for the machine.