Alle gidsen

How to price made-to-measure furniture

Gepubliceerd · 2 min lezen

Deze gids is in het Engels.

A router cutting a chipboard panel to size
A router cutting a chipboard panel to size

Most workshops price custom furniture from experience: a look at the drawing, a number that feels right. It works until you want to show prices on your website, where every size needs a price without you in the room. This guide turns the number you carry in your head into rules.

Start from what one piece costs you

List everything a piece takes, in the unit it is bought or spent in. Not "the material", but the board in square metres, the edge band in metres, each hinge and connector, the finish per square metre, and the minutes on each machine.

  • Board: what a full board costs, divided by the area you can really use from it
  • Edge banding: per metre of banded edge, including the glue and the machine
  • Machining: per cut, per hole, per cut-out, or per minute of the router
  • Hardware and finish: per item and per square metre
  • Set-up: the time to start an order, whatever its size

Turn the costs into rules

A rule is a cost the customer can see change: so much per square metre of the chosen board, so much per metre of edge, so much per hole, plus a fixed amount per piece. A shelf of 800 × 300 mm in an oak decor at €32 a square metre is 0.24 m² × €32 = €7.68 of board. Band one long edge at €1.20 a metre and add €3.50 for cutting and handling, and the shelf costs €12.14 before your margin.

Write the rules so that they still make sense at the edges of the range: the smallest piece your saw takes, the longest board you stock, a quantity of one and a quantity of fifty.

Price rules of a configurator in the Customazy panel
Price rules of a configurator in the Customazy panel

Do not forget the board you throw away

You buy whole boards, but you sell parts. The offcuts that are too small to use again are a cost of every order. Add them as a percentage on the board price, or price the share of the board a part takes. Laying parts well on the boards brings that share down, which is what the guide on nesting is about.

Minimums, set-up and quantity

A single small shelf costs you almost as much time as ten. A set-up charge per order, or a minimum order value, keeps the small orders worth doing. Quantity breaks do the opposite for the large ones: the same rules, a lower rate from ten or fifty pieces.

Check the rules against real jobs

Take the last ten jobs you quoted by hand and run them through your rules. Where a result is far from what you charged, one of the rules is missing or wrong, or the hand quote was. Fix it before the prices go online, then check again after the first month of orders.